Configuring The Event Corresponding To The Alarm Threshold; Configuring The Alarm Threshold - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Data Preparation
To configure the threshold for the NQA alarm, you need the following data.
No.
1
2
3
4
6.35.2 Configuring the Event Corresponding to the Alarm
Threshold
This part describes the actions that the system needs to perform in response to the threshold
exceeding, such as generating logs, generating traps, or generating logs and traps.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa event event-entry { log | trap | log-trap | none } [ description ]
The event number and the corresponding event are configured.
----End

6.35.3 Configuring the Alarm Threshold

This part describes how to configure the events triggered when the number of test results exceeds
the threshold.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Issue 03 (2010-09-20)
Data
Number of the event corresponding to the threshold
Number of the alarm threshold
Upper threshold
Lower threshold
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-135