Figure 6-6 Networking Diagram For Configuring The Http Test - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration

Figure 6-6 Networking diagram for configuring the HTTP test

Switch
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure reachable routes between Switch and HTTP Server. The configuration details are not
mentioned here.
Step 2 Enable the NQA client and create an NQA HTTP test.
<Quidway> system-view
[Quidway] nqa test-instance admin http
[Quidway-nqa-admin-http] test-type http
[Quidway-nqa-admin-http] destination-address ipv4 10.2.1.1
[Quidway-nqa-admin-http] http-operation get
[Quidway-nqa-admin-http] http-url www.huawei.com
Step 3 Perform the test.
[Quidway-nqa-admin-http] start now
Step 4 Verify the test result.
[Quidway-nqa-admin-http] display nqa results test-instance admin http
NQA entry(admin, http) :testflag is inactive ,testtype is http
1 . Test 1 result
6-148
10.1.1.2/24
GE1/0/0
VLANIF10
10.1.1.1/24
Configure the Switch as the NQA client.
Create and perform the HTTP test on the Switch to check whether the a connection between
the Switch and the HTTP server can be set up and to check the time for transferring a file
between them.
Host address of the HTTP server
HTTP operation type
The test is finished
SendProbe:3
Completions: success
MessageBodyOctetsSum: 0
DNSQueryError number: 0
TcpConnError number : 3
DNSRTT Sum/Min/Max:0/0/0
TransactionRTT Sum/Min/Max: 11/3/4
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
HTTP Server
10.2.1.1/24
IP
Network
ResponseProb:3
RTD OverThresholdsnumber: 0
TargetAddress: 10.2.1.1
HTTPError number: 0
System busy operation number:0
TCPConnectRTT Sum/Min/Max: 0/0/0
Issue 03 (2010-09-20)