Optional) Adjusting The Performance Of The Nqa Mtrace Test - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
The MTrace query type is specified. Correctly specifying the query type based on the network
situations helps to promptly and accurately trace the path. If the query type is not specified, the
system uses multicast-tree, by default.
l all-router: applies to the scenario where the current switch is linked to the destination host.
l destination: applies to the scenario where the unicast routes exist between the current
l last-hop: applies to the scenario where the address of the last-hop switch is specified and
l multicast-tree: applies to the scenario where the current switch is on the multicast path from
If the mtrace command is run on a specified multicast VPN network, mtrace-query-type all-
router cannot be configured.
Step 8 (Optional) Run:
mtrace-last-hop-address ipv4 ip-address
The IP address of the last-hop switch is specified.
Step 9 (Optional) Run:
source-address ipv4 ip-address
The source address of the IGMP-Tracert-Query packet, which must be the address of the local
interface, is configured. If multicast-tree is applied, this step is skipped.
Step 10 Run:
quit
Exit from the NQA test instance view.
----End
6.24.4 (Optional) Adjusting the Performance of the NQA MTrace
Test
This part describes how to set optional MTrace test parameters according to the network
operating status.
Context
Do as follows on the switch with the MTrace test being configured:
Procedure
Step 1 Run:
system-view
Issue 03 (2010-09-20)
switch and the destination host.
unicast routes exist between the current switch and the last-hop switch. When last-hop is
used, you must specify the IP address of the last-hop switch.
the multicast source to the destination host.
CAUTION
NOTE
The steps described in this procedure are all optional.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-91