Configuring User Information; Configuring A Basic Acl; Applying The Acl - Huawei Quidway S9300 Configuration Manual - Network Management

1 SNMP Configuration

1.11.4 Configuring User Information

This part describes how to create SNMP access users (access NMSs) and add these users to the
user group.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent usm-user v3 user-name group-name
Users are added into the SNMPv3 user group.
----End

1.11.5 Configuring a Basic ACL

This part describes how to configure ACLs to enable a specific NMS to access the device.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
acl acl-number
A basic ACL is created.
Step 3 Run:
rule [ rule-id ] { deny | permit } [ fragment |
wildcard | any } | time-range time-name ]
ACL rules are defined.
----End

1.11.6 Applying the ACL

This part describes how to use ACLs to filter the source address of the NM Station user.
1-34 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
source { source-address source-
*
Issue 03 (2010-09-20)