Huawei Quidway S9300 Configuration Manual - Network Management page 223

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
This section describes how to configure an MTrace test to check the RPF path from the multicast
source to the destination host.
6.24 Configuring the NQA MTrace Test to Check the Multicast Path from the Multicast Source
to the Destination Host
This section describes how to configure an MTrace test to check the multicast path from the
multicast source to the destination host.
6.25 Configuring the PWE3 Ping Test to Check the One-Hop PW
This section describes how to configure a PWE3 ping test to check the connectivity of a single-
hop pseudo-wire (PW).
6.26 Configuring the PWE3 Ping Test to Check the Multi-Hop PW
This section describes how to configure a PWE3 ping test to check the connectivity of a multi-
hop PW.
6.27 Configuring the PWE3 Trace Test to Check the One-Hop PW
This section describes how to configure a PWE3 trace test to check the communications between
devices along a PW.
6.28 Configuring the PWE3 Trace Test to Check the Multi-Hop PW
This section describes how to configure a PWE3 trace test to check the communications between
devices on a PW.
6.29 Configuring an NQA Test Group
To perform ICMP, jitter, TCP, UDP, SNMP LSP ping, LSP jitter, ICMP jitter and PWE3 ping
tests for multiple destinations, you can configure NQA test groups. You can add tests of the
same type to a test group for unified management.
6.30 Configuring Universal NQA Test Parameters
This section describes how to set and use universal parameters for NQA test instances.
6.31 Configuring Round-Trip Delay Thresholds
This section describes how to set a round-trip delay transmission threshold in an NQA test
instance.
6.32 Configuring Uni-directional Transmission Delay Thresholds
This section describes how to set a one-way transmission delay threshold in an NQA test
instance. After a one-way transmission delay threshold is set in an NQA test instance, the test
result will contain the statistics on the test packets that exceed the set threshold. This provides
the basis for the network manager to analyze the operating status of the specified service on the
network.
6.33 Configuring the Trap Function
This section describes how to configure the trap function in an NQA test instance. After the trap
function is configured, a trap message is sent to the NMS in case of transmission success or
transmission failure.
6.34 Configuring Test Results to Be Sent to the FTP Server
This section describes how to configure the system to send test results to the FTP server to avoid
loss of test results in the event that the NMS does not poll the test result in time.
6.35 Configuring a Threshold for the NQA Alarm
This section describes how to set an alarm threshold for test results. When the number of test
results exceeds the threshold, a trap message is sent to the NMS for notification.
6.36 Maintaining NQA
This section describes how to maintain an NQA test instance. You can restart the test instance,
clear the statistics on the test result, or adjust the test operating status to debug a test instance.
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-3