Example For Configuring The Snmp Query Test; Figure 6-9 Networking Diagram For Configuring The Snmp Query Test - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
l

6.37.7 Example for Configuring the SNMP Query Test

Networking Requirements
As shown in
used to measure the time from sending an SNMP query packet to receiving an Echo packet.

Figure 6-9 Networking diagram for configuring the SNMP query test

SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Issue 03 (2010-09-20)
#
interface Vlanif100
ip address 10.1.1.2 255.255.255.0
#
interface Vlanif110
ip address 10.2.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
return
Configuration file of Switch C
#
sysname SwitchC
#
vlan batch 110
#
interface Vlanif110
ip address 10.2.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
ip route-static 10.1.1.0 255.255.255.0 10.2.1.1
#
return
Figure 6-9, SNMP agent is enabled on Switch C. The NQA SNMP query test is
GE1/0/0 GE1/0/0
VLANIF100 VLANIF100
10.1.1.1/24 10.1.1.2/24
Configure Switch A as the NQA client.
Create and perform the SNMP query test on Switch A.
Enable SNMP agent on Switch C.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE2/0/0
VLANIF110 VLANIF110
10.2.1.1/24 10.2.1.2/24
6 NQA Configuration
SwitchC
GE1/0/0
SNMP Agent
6-153