Example For Configuring The Lsp Jitter Test For A Common Tunnel; Figure 6-15 Networking Diagram For Configuring The Lsp Jitter Test - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
6.37.13 Example for Configuring the LSP Jitter Test for a Common
Tunnel
Networking Requirements
As shown in
l
l
l
The NQA LSP Ping test is used to check the connectivity of the LSP between Switch A and
Switch C.

Figure 6-15 Networking diagram for configuring the LSP Jitter test

SwitchA
6-168
ip address 10.2.1.2 255.255.255.0
mpls
mpls ldp
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
interface LoopBack1
ip address 3.3.3.9 255.255.255.255
#
ospf 1
area 0.0.0.0
network 3.3.3.9 0.0.0.0
network 10.2.1.0 0.0.0.255
#
return
Figure 6-15:
The OSPF protocol runs on Switch A, Switch B, and Switch C. The three Switches learn
the 32-bit host routes on their loopback interfaces.
MPLS and MPLS LDP are enabled on Switch A, Switch B, and Switch C.
MPLS and MPLS LDP are enabled on VLANIF interfaces connected to Switch A,
Switch B, and Switch C to trigger the establishment of an LDP LSP.
Loopback1
1.1.1.9/32
GE1/0/0
VLANIF100
VLANIF100
10.1.1.1/24
10.1.1.2/24
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Configuration Guide - Network Management
area 0
Loopback1
2.2.2.9/32
GE1/0/0 GE2/0/0
VLANIF110
10.2.1.1/24
SwitchB
Quidway S9300 Terabit Routing Switch
Loopback1
3.3.3.9/32
GE1/0/0
VLANIF110
10.2.1.2/24
SwitchC
Issue 03 (2010-09-20)