Example For Configuring The Pwe3 Trace Test On A Multi-Hop Pw; Figure 6-27 Networking Diagram For Configuring The Pwe3 Trace Test On A Multi-Hop Pw - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6.37.25 Example for Configuring the PWE3 Trace Test on a Multi-
Hop PW
Networking Requirements
As shown in
through PPP. U-PE1 and U-PE2 are connected through the MPLS backbone network. The LSP
needs to be used and S-PE is set as the switching node to set up a dynamic multi-hop PW between
U-PE1 and U-PE2.
The PWE3 Trace function of the multi-hop PW needs to be performed to test the connectivity
of the PW between U-PE1 and U-PE2.

Figure 6-27 Networking diagram for configuring the PWE3 Trace test on a multi-hop PW

U-PE1
Configuration Roadmap
The configuration roadmap is as follows:
Issue 03 (2010-09-20)
#
vlan batch 140
#
interface Vlanif140
ip address 100.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 140
port hybrid untagged vlan 140
#
return
Figure 6-27, CE-A and CE-B are respectively connected to U-PE1 and U-PE2
Loopback0
2.2.2.9/32
P1
GE1/0/0
GE2/0/0
VLANIF120
VLANIF130
10.1.1.2/24
20.1.1.1/24
Loopback0
1.1.1.9/32
GE2/0/0
VLANIF120
10.1.1.1/24
GE1/0/0
VLANIF110
GE1/0/0
VLANIF110
100.1.1.1/24
CE-A
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Loopback0
3.3.3.9/32
GE1/0/0
S-PE
VLANIF130
20.1.1.2/24
GE2/0/0
VLANIF140
30.1.1.1/24
6 NQA Configuration
Loopback0
4.4.4.9/32
GE1/0/0
P2
VLANIF140
30.1.1.2/24
GE2/0/0
VLANIF150
40.1.1.1/24
Loopback0
5.5.5.9/32
GE1/0/0
VLANIF150
40.1.1.2/24
GE2/0/0
VLANIF160
CE-B
U-PE2
GE1/0/0
VLANIF160
100.1.1.2/24
6-219