Enabling Flexible Netstream On Interfaces; Checking The Configuration; Configuring The Mapping Of Netstream Interface Indexes - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
By default, the fixed-packets sampling ratio on an interface is 1000:1.
----End

7.6.6 Enabling Flexible NetStream on Interfaces

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface { ethernet | gigabitethernet | xgigabitethernet } interface-number
The interface view is displayed.
Step 3 Run:
port ip netstream record record-name
The record is applied to the interface.
----End

7.6.7 Checking the Configuration

Prerequisite
All configurations are complete.
Procedure
Step 1 Run the display netstream all command to view the NetStream configuration.
----End
7.7 Configuring the Mapping of NetStream Interface
Indexes
This section describes how to configure the mapping of NetStream interface indexes.
7.7.1 Establishing the Configuration Task
7.7.2 Mapping the NetStream Interface Indexes
7.7.3 Checking the Configuration
Issue 03 (2010-09-20)
NOTE
Only one record can be configured on an interface. To modify the record in the same interface view, you
must first delete the existing configuration by running the undo port ip netstream record command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
7-19