Examples For Configuring Rmon2; Figure 2-2 Networking Diagram For Configuring Rmon2 - Huawei Quidway S9300 Configuration Manual - Network Management

2 RMON and RMON2 Configuration
#
snmp-agent
snmp-agent local-engineid 000007DB7FFFFFFF0000017C
snmp-agent sys-info version v3
snmp-agent target-host trap address udp-domain 1.1.1.1 params securityname public
#
return

2.6.2 Examples for Configuring RMON2

Networking Requirements
As shown in
IP packets on VLANIF 10.
RMON2 can monitor remote hosts through the SNMP NMS, or through command lines. This
example describes only command-line-based monitoring.

Figure 2-2 Networking diagram for configuring RMON2

NM Station
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure a VLAN and add GE 2/0/0 to the VLAN.
2-20
Figure 2-2, RMON2 needs to be configured on the Switch to collect statistics of
Network
Assign IP addresses to interfaces of the Switch.
Configure the hlHostControlTable.
Configure the protocolDirTable.
Index of the hlHostControlTable and the maximum items in the hlHostControlTable
Protocol ID
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Configuration Guide - Network Management
COM
Console
IP
Switch
Quidway S9300 Terabit Routing Switch
Lan
GE2/0/0
VLANIF10
10.1.1.1/24
Issue 03 (2010-09-20)