Configuring Uni-Directional Transmission Delay Thresholds; Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
No.
1
2

6.32.2 Configuring Uni-directional Transmission Delay Thresholds

This part describes how to set a one-way transmission delay threshold. When the transmission
duration exceeds the threshold, a trap message is sent to the NMS.
Context
Do as follows on the switch to perform the NQA test:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the NQA instance view is displayed.
Step 3 Run:
threshold owd-sd owd-sd-value
The uni-directional transmission (from the source to the destination) delay threshold is
configured.
Step 4 Run:
threshold owd-sd owd-sd-value
The uni-directional transmission (from the destination to the source) delay threshold is
configured.
----End

6.32.3 Checking the Configuration

After setting the one-way transmission delay threshold, you can view the configuration.
Prerequisite
The configurations of the Uni-directional Transmission Delay Thresholds Test function are
complete.
Issue 03 (2010-09-20)
Data
Administrator name and test name
Uni-directional transmission delay threshold
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-123