Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type trace
The test type is set to Traceroute.
Step 4 Run:
destination-address ipv4 ip-address
The destination address of the Traceroute test is configured.
Step 5 Perform the following as required to configure other parameters for the Traceroute test.
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
l To configure the maximum hops, run the tracert-hopfailtimes timescommand.
l To configure the initial TTL value and the maximum TTL value, run the tracert-livetime
l To configure the type of service (ToS) value of the test packet, run the tos value command.
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the destination port number, run the destination-port port-number command.
l To configure the NQA test packets to be sent without searching the routing table, run the
Step 6 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
----End

6.10.3 Checking the Configuration

After configuring the traceroute test, you can view the test result.
Prerequisite
The configurations of the Traceroute Test function are complete.
6-26
command.
first-ttl first-ttl max-ttl max-ttl command.
sendpacket passroute command.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)