Configuring The Snmp Query Test Parameters - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
Applicable Environment
Through the SNMP Query test, you can obtain the statistics of the communication between hosts
and SNMP agents.
Pre-configuration Tasks
Before configuring the SNMP Query test, complete the following tasks:
l
l
Data Preparation
To configure the SNMP query test, you need the following data.
No.
1
2
3
4

6.11.2 Configuring the SNMP Query Test Parameters

This part describes how to set SNMP query test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type snmp
The test type is set to SNMP Query.
Step 4 Run:
destination-address ipv4 ip-address
6-28
Configuring the SNMP agent
Configuring routes between the NQA client and the SNMP agent
Data
Administrator name and test name
IP address of the SNMP agent
(Optional) Source IP addresses and source port numbers of test packets, interval for
sending test packets, and percentage of the failed NQA tests
Start mode and end mode of the test
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)