Figure 6-29 Network Diagram For Configuring The Nqa Threshold - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management

Figure 6-29 Network diagram for configuring the NQA threshold

VLANIF110
20.1.1.1/24
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure a Jitter test.
# Configure the IP address and UDP port number monitored by the NQA server on Switch C.
<SwitchC> system-view
[SwitchC] nqa-server udpecho 30.1.1.2 9000
# # Enable the NQA client on Switch A and create an NQA Jitter test on it.
<SwitchA> system-view
[SwitchA] nqa test-instance admin jitter
[SwitchA-nqa-admin-jitter] test-type jitter
Issue 03 (2010-09-20)
GE2/0/0
GE1/0/0
GE1/0/0
VLANIF120 VLANIF120
10.1.1.1/24
10.1.1.2/24
NOTE
For the information about clock synchronization, see "NTP" in the Quidway S9300 Terabit Routing Switch
Feature Description - Network Management.
Configure a Jitter test.
Configure the NQA thresholds.
Enable the function of sending trap messages.
Configure the function of sending trap messages to the NMS.
IP address and port number of the server-side host.
Type of the monitored service and monitoring port number
RTD threshold and OWD threshold
IP address of the NMS
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
NM Station
20.1.1.2/24
GE1/0/0
SwitchB
VLANIF130
30.1.1.2/24
GE2/0/0
VLANIF130
30.1.1.1/24
6 NQA Configuration
SwitchC
NQA Server
6-229