Configuring The Alarmtable; Configuring The Prialarmtable - Huawei Quidway S9300 Configuration Manual - Network Management

Terabit routing switch
Hide thumbs Also See for Quidway S9300:
Table of Contents

Advertisement

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management

2.3.6 Configuring the AlarmTable

The RMON alarm management function monitors a specified trap variable identified by its OID
at a specified sampling interval. When the monitored variable exceeds the defined threshold, an
alarm is generated.
Context
The RMON alarm management is responsible for monitoring a specified alarm variable
(identified by OID) at a specified sampling interval. An alarm event occurs when the monitored
variable exceeds the defined threshold. Generally, the event is recorded in the log table, or
RMON sends a trap message to the NM Station.
If the events that correspond to the alarm upper limit and lower limit (event-entry1, event-
entry2) are not configured in the eventTable, an alarm is not generated even if the alarm condition
is satisfied. At this time, the status of alarm recording is undercreation and not VALID.
If an event corresponding to either the alarm upper limit or the alarm lower limit is configured,
an alarm is triggered once the alarm condition is satisfied. At this time, the status of alarm
recording is VALID. If an incorrect alarm variable is configured (for example, an inexistent OID
is specified), the status of alarm recording is undercreation and no alarm is generated.
Do as follows on the switch that is monitored:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
rmon alarm entry-number alarm-OID sampling-time { delta | absolute } rising-
threshold threshold-value1 event-entry1 falling-threshold threshold-value2 event-
entry2 [ owner owner-name ]
The alarmTable is configured.
----End

2.3.7 Configuring the PrialarmTable

Compared with AlarmTable, PrialarmTable is enhanced with the function of setting the trap
object through an expression.
Context
Do as follows on the switch that is monitored.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Issue 03 (2010-09-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 RMON and RMON2 Configuration
2-9

Advertisement

Table of Contents
loading

Table of Contents