Example For Configuring Mad In Direct Mode - Huawei S Series White Paper

S Series Switches
iStack Technology White Paper
-------------------------------------------------------------
0
1
Step 5 Configure a user VLAN and add the interfaces that connect access switches to the VLAN.
<SwitchA> system-view
[SwitchA] vlan 100
[SwitchA] vlan 100
[SwitchA-vlan100] quit
[SwitchA] interface XGigabitEthernet 0/0/5
[SwitchA-XGigabitEthernet 0/0/5] port link-type trunk
[SwitchA-XGigabitEthernet 0/0/5] port trunk allow-pass vlan 100
[SwitchA-XGigabitEthernet 0/0/5] quit
[SwitchA] interface XGigabitEthernet 1/0/5
[SwitchA-XGigabitEthernet 1/0/5] port link-type trunk
[SwitchA-XGigabitEthernet 1/0/5] port trunk allow-pass vlan 100
[SwitchA-XGigabitEthernet 1/0/5] quit
Step 6 Configure an Eth-Trunk and add uplink interfaces to the Eth-Trunk.
<SwitchA> system-view
[SwitchA] interface Eth-Trunk 10
[SwitchA-Eth-Trunk10] port link-type trunk
[SwitchA-Eth-Trunk10] port trunk allow-pass vlan 100
[SwitchA-Eth-Trunk10] trunkport XGigabitEthernet 0/0/20 to 0/0/21
[SwitchA-Eth-Trunk10] trunkport XGigabitEthernet 1/0/20 to 1/0/21
[SwitchA-Eth-Trunk10] quit
----End

4.3 Example for Configuring MAD in Direct Mode

Networking Requirements
As shown in Figure 4-3, SwitchA and SwitchB form a stack. The stack IDs of SwitchA and
SwitchB are 0 and 1 respectively.
To ensure stack reliability, MAD in direct mode needs to be configured on
GigabitEthernet0/0/5 and GigabitEthernet1/0/5. When the stack splits because of a stack link
fault and there are two devices with the same configuration on the network, you can use MAD
to reduce the impact of a stack split on the network.
Issue 01 (2013-05-25)
Master 80fb-06af-7570
Standby 80fb-06af-7ed0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
100 S6700-48-EI
100 S6700-48-EI
4 Application Scenarios
49