Huawei Quidway S9300 Configuration Manual - Network Management page 488

7 NetStream Configuration
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
Procedure
Step 1 Set IP addresses for the interfaces on Switch A and Switch B. The configuration procedure is
not mentioned here.
Step 2 Configure the IGP route between Switch A and Switch B.
# Configure the dynamic route on Switch A.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] ospf router-id 1.1.1.1
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 10.1.1.1 0.0.0.255
# Configure the dynamic route on Switch B.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] ospf router-id 2.2.2.2
[SwitchB-ospf-1] area 0
[SwitchB-ospf-1-area-0.0.0.0] network 10.1.1.2 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] network 10.2.1.1 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] network 10.3.1.1 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] quit
[SwitchB-ospf-1] quit
Step 3 Set up BGP peer relations between Switch B, Switch C, and Switch D.
# Set up dynamic BGP peer relations between Switch B and Switch C.
[SwitchB] bgp 65001
[SwitchB-bgp] router-id 2.2.2.2
[SwitchB-bgp] peer 10.2.1.2 as-number 65002
[SwitchB-bgp] ipv4-family unicast
[SwitchB-bgp-af-ipv4] import-route ospf 1
[SwitchB-bgp-af-ipv4]quit
[SwitchB-bgp]quit
[SwitchC] bgp 65002
[SwitchC-bgp] route-id 3.3.3.3
[SwitchC-bgp] peer 10.2.1.1 as-number 65001
7-26
Configure a reachable route between the user network and access network.
Configure a reachable route between the access network and ISP 1, and between the access
network and ISP 2.
Enable the NetStream function on Switch B.
IP addresses of interfaces
OSPF process ID
BGP process ID
NSC address and port number
Sampling ratio
Version number of exported packets
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)