Establishing The Configuration Task; Figure 4-1 Networking Diagram For Configuring Lldp - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management

4.3.1 Establishing the Configuration Task

Applicable Environment
The LLDP function is used to obtain neighbor information and discover the topology. As shown
in Figure
B exchanges status information, and thus the NMS can collect the topology information about
Switch A and Switch B.
To facilitate NMS management, you need to configure management addresses on Switch A and
Switch B. In addition, you should enable the LLDP trap function on the switchs. In this way,
the switchs can send trap messages to the NMS when network topology changes.

Figure 4-1 Networking diagram for configuring LLDP

Pre-configuration Tasks
Before configuring LLDP, complete the following task:
l
Issue 03 (2010-09-20)
4-1, you can configure LLDP on Switch A and Switch B. Then, Switch A and Switch
LLDPDU
SwitchA
LLDP interface Non-LLDP interface
PBB-TE Tunnel or MPLS LSP
NMS: Network Management System
Configuring the LLDP management addresses
NOTE
The management address of LLDP contained in an LLDP packet is used to identify a device. You need to
select an IP address that the NMS can identify and manage easily, for example, the IP address of an MEth
interface. The management address must be an existing IP address on the device. Therefore, this IP address
must be configured before
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
NMS
SwitchB
4.3.5 (optional) Configuring an LLDP Management
4 LLDP Configuration
Address.
4-5