Example For Configuring Basic Hgmp Functions For A Cluster - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
8.5.6 Example for Configuring the Batch Distribution Function for an HGMP Cluster
8.5.7 Example for Configuring the Batch Restart Function for an HGMP Cluster
8.5.8 Example for Configuring the Incremental Configuration Function for an HGMP Cluster
8.5.9 Example for Configuring the Configuration Synchronization Function for an HGMP
Cluster
8.5.10 Example for Configuring Security Features for an HGMP Cluster

8.5.1 Example for Configuring Basic HGMP Functions for a Cluster

Networking Requirements
As shown in
Layer 2 devices are hard to be maintained and managed on the site. In addition, to save public
IP addresses, you cannot assign a public IP address to each device.
To effectively manage the Layer 2 network, you can create a cluster for the Layer 2 network
and manage the cluster through HGMP.
In this example, Administrator-1 is nearest to the network administrator and is therefore
appointed as the administrator switch.
Issue 03 (2010-09-20)
Figure 8-3, a carrier sets up a Layer 2 network through Layer 2 devices. Too many
NOTE
For convenience, only four devices in the Layer 2 network are described.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 HGMP Configuration
8-33