Checking The Configuration; Configuring The Nqa Mtrace Test To Check The Rpf Path From The Multicast Source To The Destination Host - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
start now
The NQA MTrace test is started.
Step 4 Run:
quit
Exit from the test instance view.
----End

6.22.6 Checking the Configuration

After performing the MTrace test for the multicast path from the multicast source to the querier,
you can view the test result.
Prerequisite
The configurations of the NQA MTrace Test function are complete.
Context
Procedure
l
l
l
l
----End
Example
Run the display nqa-agent command. If information about the NQA test is displayed, it means
that the test is successful. For example:
<Quidway> display nqa-agent admin aa verbose
nqa test-instance admin aa
test-type mtrace
mtrace-source-address ipv4 11.1.0.1
mtrace-group-address ipv4 225.0.0.1
nqa status : normal
6.23 Configuring the NQA MTrace Test to Check the RPF
Path from the Multicast Source to the Destination Host
This section describes how to configure an MTrace test to check the RPF path from the multicast
source to the destination host.
6.23.1 Establishing the Configuration Task
Issue 03 (2010-09-20)
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
Run the display nqa-agent [ admin-name test-name ] [ verbose ] to view the status of the
test instance configured on the NQA client.
Run the display nqa results command to view the test results on the NQA client.
Run the display nqa history command to view the history of the NQA test.
Run the display mtrace statistics command to view the statistics of the MTrace packets.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-81