Huawei Quidway S9300 Configuration Manual - Network Management page 386

6 NQA Configuration
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure LDP on Switch A, Switch B, and Switch C. (The detailed procedure is not mentioned
here.)
For the configuration of LDP, refer to the Quidway S9300 Terabit Routing Switch Configuration
Guide - MPLS.
Step 3 # Configure Switch A.
# Enable the NQA client and create an LSP Ping test for a common tunnel.
<SwitchA> system-view
[SwitchA] nqa test-instance admin lspping
[SwitchA-nqa-admin-lspping] test-type lspping
[SwitchA-nqa-admin-lspping] lsp-type ipv4
[SwitchA-nqa-admin-lspping] destination-address ipv4 3.3.3.9 lsp-masklen 32
Step 4 Perform the test.
[SwitchA-nqa-admin-lspping] start now
Step 5 Verify the test result.
[SwitchA-nqa-admin-lspping] display nqa results test-instance admin lspping
NQA entry(admin, lspping) :testFlag is inactive ,testtype is
1 . Test 1 result
----End
Configuration Files
l
6-166
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Min Positive Jitter: 0
Max Positive Jitter: 0
Positive Jitter Num: 0
Positive Jitter Sum: 0
Positive Jitter Square Sum: 0
Packet Loss: 0
Destination ip address:3.3.3.9
Min/Max/Average Completion Time: 1/1/1
Sum/Square-Sum Completion Time: 3/3
Last Good Probe Time: 2009-2-1 15:32:56.1
Configuration file of Switch A
#
sysname SwitchA
#
vlan batch 100
#
mpls lsr-id 1.1.1.9
mpls
#
mpls ldp
#
interface Vlanif100
ip address 10.1.1.1 255.255.255.0
mpls
mpls ldp
#
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
Min Negative Jitter: 0
Max Negative Jitter: 0
Negative Jitter Num: 0
Negative Jitter Sum: 0
Negative Jitter Square Sum: 0
Packet Loss Ratio: 0
lspping
Issue 03 (2010-09-20)