Configuring Parameters For The Icmp Jitter Test - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
according to the information received on the source. Based on these data, the network status is
clearly presented.
In the jitter test, you can set the number of packets to be sent consecutively in each test instance.
Through this setting, the actual traffic of a kind of packet during a time period can be simulated.
If the server is a non-Huawei device, you can test the jitter of the network by configuring an
ICMP jitter test instance.
Pre-configuration Tasks
Before configuring an ICMP jitter test, configure a reachable route between the NQA client and
the server.
Data Preparation
To configure a jitter test, you need the following data.
No.
1
2
3
4

6.19.2 Configuring Parameters for the ICMP Jitter Test

This part describes how to set ICMP jitter test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa-jitter tag-version version-number
The version number of jitter packet is configured.
Step 3 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Issue 03 (2010-09-20)
Data
Administrator of the NQA test instance and name of the test instance
Destination IP address
(Optional) Name of a VPN instance, source IP address ,number of test probes sent
each time, number of test packets sent each time, interval for sending test packets,
ratio of the failed NQA tests, and version number of jitter packets
Start mode and end mode
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-65