Checking The Configuration; Maintaining Nqa - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management

6.35.5 Checking the Configuration

After the alarm threshold for test results is set, you can view the configuration.
Prerequisite
The configurations of the Threshold for the NQA Alarm function are complete.
Procedure
l
l
l
----End
Example
Run the display nqa event command to check the maximum number of events that can be
configured and the number of events that are configured.
<Quidway> display nqa event
NQA event information:
------------------------------------------------------
NQA Event Max: 5
------------------------------------------------------
Run the display nqa-alarm command to check the maximum number of alarms that can be
configured and the number of alarms that are configured.
[Quidway-nqa-admin-icmp] display nqa alarm
NQA alarm information:
------------------------------------------------------
NQA Alarm Max: 5
------------------------------------------------------
Run the display nqa agent command to check the status of the test instance configured on the
NQA client.
<Quidway> display nqa-agent
NQA Tests Max:2000
NQA Flow
nqa test-instance admin icmp
test-type icmp
destination-address ipv4 11.1.1.32
frequency 5
alarm 10 rtt-average 2 rising-threshold 200 10 falling-threshold 0 10
alarm 20 lost-packet-ratio 2 rising-threshold 10 10 falling-threshold 1 10
nqa status : normal

6.36 Maintaining NQA

This section describes how to maintain an NQA test instance. You can restart the test instance,
clear the statistics on the test result, or adjust the test operating status to debug a test instance.
6.36.1 Restarting NQA Test Instances
Issue 03 (2010-09-20)
Run the display nqa event command to check the maximum number of events that can be
configured and the number of events that are configured.
Run the display nqa alarm command in the NQA view to check the maximum number of
alarms that can be configured and the number of alarms that are configured.
Run the display nqa-agent [ admin-name test-name ] [ verbose ] command to Check the
status of the test instance configured on the NQA client.
Max:1000
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
NQA Event Number: 1
NQA Alarm Number: 2
NQA Tests Number:
NQA Flow Remained:1000
6 NQA Configuration
1
6-137