Establishing The Configuration Task; Configuring The Netstream Function On An Interface - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
7.5.5 Configuring the Aggregation Function
7.5.6 Checking the Configuration

7.5.1 Establishing the Configuration Task

Applicable Environment
When the NetStream function is configured in the IPv4 network, a mode of collecting statistics
about aggregation traffic must be configured to classify statistics about packets according to
certain rules.
Pre-configuration Tasks
Before configuring NetStream for aggregation traffic, complete the following tasks:
l
l
Data Preparation
To complete the configuration, you need the following data.
No.
1
2
3

7.5.2 Configuring the NetStream Function on an Interface

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface { ethernet | gigabitethernet | xgigabitethernet } interface-number
The interface view is displayed.
Step 3 Run:
ip netstream { inbound | outbound }
The NetStream function is enabled on the interface to collect statistics about IPv4 unicast traffic.
By default, the NetStream function is disabled in inbound and outbound directions.
Issue 03 (2010-09-20)
Setting physical parameters on an interface
Setting the link-layer parameters of the interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
Data
Name and number of the interface on which
traffic statistics need to be collected
Version number of exported packets of the
NetStream traffic statistics
IP addresses and port numbers of the NSC
7-13