Establishing The Configuration Task; Configuring The Snmp Version - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management

1.6.1 Establishing the Configuration Task

Before configuring community-name-based access control in SNMPv2c, familiarize yourself
with the applicable environment, complete the pre-configuration tasks, and obtain the required
data. This can help you complete the configuration task quickly and accurately.
Applicable Environment
To configure the specified NM Station to manage the switch (SNMP agent), configure access
control lists on the switch.
Pre-configuration Tasks
Before configuring community-name-based access control, complete the following tasks:
l
l
Data Preparation
To configure community-name-based access control, you need the following data.
No.
1
2

1.6.2 Configuring the SNMP Version

By default, the NM Station accesses the device through SNMPv3. To enable the NM Station to
access the device through SNMPv2c, you need to configure SNMPv2c on the device.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent sys-info version v2c
The SNMP version is configured.
By default, SNMPv3 is configured.
----End
Issue 03 (2010-09-20)
Assigning an IP address to the switch
Configuring the routing protocol to make the switch and the NM Station accessible
Data
ACL number
SNMP community name
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SNMP Configuration
1-15