Example For Checking The Rpf Path From The Source To Destination Host Through The Mtrace Test; Figure 6-22 Networking Diagram For Checking The Multicast Path From The Multicast Source To The Local Switch - Huawei Quidway S9300 Configuration Manual - Network Management

Terabit routing switch

Hide thumbs Also See for Quidway S9300:

Table of Contents

6 NQA Configuration

6.37.20 Example for Checking the RPF Path from the Source to

Destination Host Through the MTrace Test

Networking Requirements

all Switches to make Switches work synchronously, Receiver is added to the multicast group

225.1.1.1 and receives multicast data from Source normally. Switch B is the Switch at the last

hop. This test is performed to check how the traffic is transmitted to Receiver from Source along

the RPF route.

You need to configure an NQA MTrace test on Switch C to implement the MTrace function.

You can check the RPF path from the multicast source to the destination host.

Figure 6-22 Networking diagram for checking the multicast path from the multicast source to

the local Switch

network 11.1.1.0 0.0.0.255

network 11.1.2.0 0.0.0.255

6-22, on the PIM-SM multicast network, implement the NTP protocal on

Huawei Proprietary and Confidential

Quidway S9300 Terabit Routing Switch

Configuration Guide - Network Management

Issue 03 (2010-09-20)