Huawei Quidway S9300 Configuration Manual - Network Management page 199

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)
MED system information
Device class :Network Connectivity
(MED inventory information of master board)
HardwareRev :LE02SRUA VER.A
FirmwareRev :NC
SoftwareRev :Version 5.70 V100R003C00B042
SerialNum :NA
Manufacturer name :NA
Model name :NA
Asset tracking identifier :NA
System configuration
LLDP Status
LLDP Message Tx Interval
LLDP Message Tx Hold Multiplier :4
LLDP Refresh Delay
LLDP Tx Delay
LLDP Notification Interval
LLDP Notification Enable
Management Address
Remote Table Statistics:
Remote Table Last Change Time
Remote Neighbors Added
Remote Neighbors Deleted
Remote Neighbors Dropped
Remote Neighbors Aged
Total Neighbors
Port information:
Interface GigabitEthernet1/0/1:
LLDP Enable Status
Total Neighbors
Port ID subtype :interfaceName
Port ID :GigabitEthernet1/0/1
Port description :HUAWEI, Quidway Series, GigabitEthernet1/0/1 Interface
Port And Protocol vlan ID(PPVID) don't supported
Port VLAN ID(PVID) :0
VLAN name of VLAN 1: vlan1
Protocol identity :STP RSTP/MSTP LACP EthOAM CFM
Auto-negotiation supported
Auto-negotiation enabled
OperMau :speed(1000)/duplex(Full)
Power port class
PSE power supported
PSE power enabled
PSE pairs control ability:No
Power pairs
Port power classification:Unknown
Link aggregation supported:No
Link aggregation enabled :No
Aggregation port ID
Maximum frame Size
MED port information
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
:enabled
:60
:2
:9
:10
:enabled
:IP: 10.10.10.1
:0 days, 0 hours, 0 minutes, 0 seconds
:0
:0
:0
:0
:1
:enabled
:1
:Yes
:Yes
:PD
:No
:No
:Unknown
:0
:1526
4 LLDP Configuration
(default is disabled)
(default is 30s)
(default is 4)
(default is 2s)
(default is 2s)
(default is 5s)
(default is disabled)
(default is disabled)
4-19