Establishing The Configuration Task; Configuring The Netstream Function On An Interface - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
7.4.3 (Optional) Configuring the Format of Exported Packets
IPv6 original traffic can be exported only in the v9 format. Therefore, the output format must
be configured to v9 for IPv6 traffic.
7.4.4 Setting the Destination Address of Statistics
7.4.5 (Optional) Aging the TCP Traffic According to Its FIN Flag
7.4.6 (Optional) Configuring the Inactive Aging Time of the Original Traffic
7.4.7 Checking the Configuration

7.4.1 Establishing the Configuration Task

Applicable Environment
You need to configure the NetStream on an interface to collect statistics about inbound and
outbound IPv6 packets respectively. The statistics result is sent to the Network Management
System (NMS). By analyzing the traffic statistics, the NMS can obtain the traffic situation on
the network and thus performs effective network management.
Pre-configuration Tasks
Before configuring the statistics about the original traffic, complete the following tasks:
l
l
Data Preparation
To configure NetStream, you need the following data.
No.
1
2
3

7.4.2 Configuring the NetStream Function on an Interface

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface { ethernet | gigabitethernet | xgigabitethernet } interface-number
Issue 03 (2010-09-20)
Setting physical parameters on an interface
Setting the link-layer parameters of the interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
Data
Name and number of the interface on which
traffic statistics need to be collected
Version of the exported packets of the
NetStream traffic statistics
IP addresses and port numbers of the NSC
7-9