Configuring The Eventtable - Huawei Quidway S9300 Configuration Manual - Network Management

2 RMON and RMON2 Configuration
Do as follows on the switch on which traffic statistics should be collected:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface { ethernet | gigabitethernet | xgigabitethernet } interface-number
The interface view is displayed.
Step 3 Run:
rmon history entry-number buckets number interval sampling-interval [ owner owner-
name ]
The historyControlTable is configured.
----End

2.3.5 Configuring the EventTable

After EventTable is configured, when the number of events exceeds the alarm threshold, the
switch generates logs, sends traps, or generates logs and sends traps.
Context
Do as follows on the switch that is monitored:
The RMON event management module is responsible for adding events to the corresponding
rows in the eventTable and defining the methods of processing events:
l
l
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
rmon event entry-number [ description string ] { log | trap object | log-trap
object | none } [ owner owner-name ]
The eventTable is configured.
----End
2-8
NOTE
To reduce the effect on the performance of the system, the sampling interval of the history table should be
longer than 10 seconds, and the same port should not be configured with too many history control entries
and alarm entries.
log: sending only logs
log-trap: sending both logs and trap messages to the NM Station
none: marking that no event occurs
trap: sending trap messages to the NM Station
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)