Huawei Quidway S9300 Configuration Manual - Network Management page 440

6 NQA Configuration
1.
2.
3.
4.
5.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Configure a dynamic multi-hop PW.
Configure a dynamic multi-hop PW on the MPLS backbone network.
For the detailed configuration procedure, see "PWE3 Configuration" in the Quidway S9300
Terabit Routing Switch Configuration Guide - VPN.
Step 2 Configure a PWE3 Trace test of the multi-hop PW.
# Configure U-PE1.
<U-PE1> system-view
[U-PE1] nqa test-instance test pwe3trace
[U-PE1-nqa-test-pwe3trace] test-type pwe3trace
[U-PE1-nqa-test-pwe3trace] local-pw-id 100
[U-PE1-nqa-test-pwe3trace] local-pw-type ppp
[U-PE1-nqa-test-pwe3trace] label-type control-word
[U-PE1-nqa-test-pwe3trace] remote-pw-id 200
Step 3 Perform the test.
[U-PE1-nqa-test-pwe3trace] start now
Step 4 Verify the test result.
After running the display nqa history command on the PE device, you can see that the status
is successful.
[U-PE1-nqa-test-pwe3trace] display nqa history
NQA entry(test, pwe3trace)
history:
Index
1
2
3
4
5
6
6-220
Run the IGP protocol on the backbone network to make the routes between Switches on
the backbone network reachable.
Configure the basic MPLS functions on the backbone network and set up an LSP tunnel.
Set up MPLS LDP peer relations between U-PE1 and S-PE, and between U-PE2 and S-
PE.
Create an MPLS L2VC connection between the two U-PEs.
Create a switching PW on the switching node S-PE.
Configure a PWE3 Trace test on the multi-hop PW on U-PE1.
L2VC IDs on U-PE1 and U-PE2, which must be different
MPLS LSR-IDs of U-PE1, S-PE, and U-PE2
IP address of the remote peer
Encapsulation type of the switching PW
Name and parameters of the PW template on U-PE devices
T/H/P Response Status
1/1/1
1/1/2
1/1/3
1/2/1
1/2/2
1/2/3
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Configuration Guide - Network Management
Address
4 success 10.1.1.2
5 success 10.1.1.2
3 success 10.1.1.2
6 success 20.1.1.2
6 success 20.1.1.2
6 success 20.1.1.2
Quidway S9300 Terabit Routing Switch
Time
2006-9-30 9:33:3.301
2006-9-30 9:33:3.307
2006-9-30 9:33:3.311
2006-9-30 9:33:3.318
2006-9-30 9:33:3.324
2006-9-30 9:33:3.331
Issue 03 (2010-09-20)