Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
l To perform the NQA test after a certain period of delay, run the start delay { seconds
----End
6.16.5 Checking the Configuration
After configuring the LSP ping test, you can view the test result.
Prerequisite
The configurations of the LSP Ping Test function are complete.
Context
Procedure
Step 1 Run the display nqa results command to view the test results on the NQA client.
----End
Example
Run the display nqa results command. If the test is successful, the following is displayed.
l
l
l
<Quidway> display nqa results
NQA entry(admin, test) :testFlag is inactive ,testtype is lspping
1 . Test 1 result
Issue 03 (2010-09-20)
second | hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second |
hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ] command.
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
Statistics about errors
– Number of unroutable connections
– Number of wrong sequence numbers
– Timeout times of the test packets
History statistics of each test packet
– Timestamp added when each test packet is sent
– Timestamp added when each test packet is received
– Packets status displayed on the NQA client
Statistics of results of each test
– Number of successful tests
– Sum of the response time of all tests
– RTT square sum(high 32 bit and low 32 bit)
– Minimum RTT and maximum RTT of the packet
– Destination IP address and the type of the destination IP address
– Number of the Echo packets and the sent packets
– Time when the last packet is received
The test is finished
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-51