Configuring Parameters For Connecting The Ftp Server - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
Pre-configuration Tasks
Before configuring test results to be sent to the FTP server, complete the following tasks:
l
l
l
Data Preparation
To configure test results to be sent to the FTP server, you need the following data.
No.
1
2
3
4

6.34.2 Configuring Parameters for Connecting the FTP Server

This part describes how to set parameters for accessing the FTP server that receives the test
results, such as address of the FTP server and user name and password for accessing the FTP
server.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa-ftp-record ip-address ip-address
or
nqa-ftp-record vpn-instance vpn-instance
The IP address of the FTP server is configured.
Step 3 Run:
nqa-ftp-record username username
The user name for logging into the FTP server is configured.
Step 4 Run:
nqa-ftp-record password password
6-130
Configuring the FTP server
Configuring a reachable route between the NQA client and the NM station
Configuring a test instance
Data
IP address of the FTP server
User name and password used for logging into the FTP server
Number of test results saved through FTP
Duration of saving test results through FTP
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)