Example For Configuring The Lsp Traceroute Test For The Te Tunnel; Figure 6-17 Networking Diagram For Configuring The Lsp Traceroute Test - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6.37.15 Example for Configuring the LSP Traceroute Test for the TE
Tunnel
Networking Requirements
As shown in
l
l
l
The NQA LSP traceroute test is used to test the TE tunnel.

Figure 6-17 Networking diagram for configuring the LSP traceroute test

SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
Issue 03 (2010-09-20)
interface GigabitEthernet1/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
interface LoopBack1
ip address 3.3.3.9 255.255.255.255
#
ospf 1
opaque-capability enable
area 0.0.0.0
network 3.3.3.9 0.0.0.0
network 10.2.1.0 0.0.0.255
mpls-te enable
#
return
Figure 6-17:
The OSPF protocol runs on Switch A, Switch B, and Switch C. The three Switches learn
the 32-bit host routes on their loopback interfaces.
MPLS, MPLS TE, and MPLS RSVP-TE are enabled on Switch A, Switch B, and Switch
C.
MPLS, MPLS TE, and MPLS RSVP-TE are enabled on the VLANIF interfaces connected
toSwitch A, Switch B, and Switch C to set up a TE tunnel from Switch A to Switch C.
Loopback1
1.1.1.9/32
GE1/0/0
VLANIF100
VLANIF100
10.1.1.1/24
10.1.1.2/24
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
area 0
Loopback1
2.2.2.9/32
GE2/0/0
GE1/0/0
VLANIF110
10.2.1.1/24
SwitchB
6 NQA Configuration
Loopback1
3.3.3.9/32
GE1/0/0
VLANIF110
10.2.1.2/24
SwitchC
6-175