Example For Configuring Flexible Netstream; Figure 7-4 Networking Diagram For Configuring Flexible Netstream - Huawei Quidway S9300 Configuration Manual - Network Management

7 NetStream Configuration

7.9.3 Example for Configuring Flexible NetStream

Networking Requirements
As shown in
Switch A. The Flexible NetStream feature is configured on GE 1/0/0 of Switch B. Then you can
aggregate traffic based on destination IP addresses and port numbers, collect statistics on the
inbound traffic and outbound traffic on an interface, and send the traffic statistics to the NSC.

Figure 7-4 Networking diagram for configuring Flexible NetStream

Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Set the IP addresses for the interfaces of Switch A and Switch B, as shown in
configuration procedure is not mentioned here.
Step 2 Specify the version of the exported packets.
# Set the version of the exported packets to V9.
7-30
Figure 7-4, the enterprise network is connected to Switch B of the carrier through
User
GE 1/0/0
Network
VLANIF 100
10.1.1.1/24
SwitchA
Set IP addresses for the interfaces on Switch A and Switch B.
Specify the version of the exported packets.
Configure the source address, destination address, and destination port number for
exporting packets.
Configure the Flexible NetStream feature on GE 1/0/0 of Switch B.
IP address of each interface
Version of the exported packets
Address and port number of the NSC and the source address contained in the packets
Traffic statistics to be sent to the NSC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
GE 2/0/0
VLANIF 200
10.2.1.1/24
NSC&NDA
10.2.1.2/24
GE 1/0/0
VLANIF 100
10.1.1.2/24
SwitchB
Figure 7-4. The
Issue 03 (2010-09-20)