Configuring A Threshold For The Nqa Alarm; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
<Quidway> display nqa-ftp-record configuration
---------------NQA FTP SAVE RECORD CONFIGURATION---------------

6.35 Configuring a Threshold for the NQA Alarm

This section describes how to set an alarm threshold for test results. When the number of test
results exceeds the threshold, a trap message is sent to the NMS for notification.

6.35.1 Establishing the Configuration Task

Before setting an alarm threshold for test results, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the required data. This can help
you complete the configuration task quickly and accurately.
6.35.2 Configuring the Event Corresponding to the Alarm Threshold
This part describes the actions that the system needs to perform in response to the threshold
exceeding, such as generating logs, generating traps, or generating logs and traps.
6.35.3 Configuring the Alarm Threshold
This part describes how to configure the events triggered when the number of test results exceeds
the threshold.
6.35.4 Starting the Test Instance
You can start a test instance. When the number of test results exceeds the threshold,
corresponding action is taken.
6.35.5 Checking the Configuration
After the alarm threshold for test results is set, you can view the configuration.
6.35.1 Establishing the Configuration Task
Before setting an alarm threshold for test results, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the required data. This can help
you complete the configuration task quickly and accurately.
Applicable Environment
The user can monitor the network by configuring an alarm threshold. After monitoring
conditions are configured, when the monitored item in the test result exceeds the configured
upper or lower threshold, the device sends alarms to the NM station. Therefore, the user can
monitor the real-time operation status of the network.
Pre-configuration Tasks
Before configuring the threshold for the NQA alarm, complete the following task:
l
6-134
FUNCTION: ENABLE TRAP: DISABLE
IP-ADDRESS:11.1.1.8
VPN-INSTANCE:
USERNAME:wang
PASSWORD:123
FILENAME:icmp
ITEM-NUM:10010
TIME:2
LAST FINISHED FILENAME:icmp20080605-150350.txt
Configuring a test instance
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)