Huawei Quidway S9300 Configuration Manual - Network Management page 362

6 NQA Configuration
Step 2 Configure the VLANIF interface and assign an IP address to the VLANIF interface.
# Configure Switch A.
[SwitchA] interface vlanif 10
[SwitchA-Vlanif10] ip address 10.1.1.1 24
# Configure Switch B.
[SwitchB] interface vlanif 10
[SwitchB-Vlanif10] ip address 10.1.1.2 24
Step 3 Enable the NQA client and create an NQA ICMP test.
[SwitchA] nqa test-instance admin icmp
[SwitchA-nqa-admin-icmp] test-type icmp
[SwitchA-nqa-admin-icmp] destination-address ipv4 10.1.1.2
Step 4 Perform the test immediately.
[SwitchA-nqa-admin-icmp] start now
Step 5 Verify the test result.
[SwitchA-nqa-admin-icmp] display nqa results test-instance admin icmp
NQA entry(admin, icmp) :testflag is inactive ,testtype is icmp
1 . Test 1 result
----End
Configuration Files
l
l
6-142
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:10.1.1.2
Min/Max/Average Completion Time: 1/30/17
Sum/Square-Sum Completion Time: 51/1301
Last Good Probe Time: 2010-06-09 19:27:48.1
Lost packet ratio: 0 %
Configuration file of Switch A
#
sysname SwitchA
#
vlan batch 10
#
interface Vlanif10
ip address 10.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
nqa test-instance admin icmp
test-type icmp
destination-address ipv4 10.1.1.2
#
return
Configuration file of Switch B
#
sysname SwitchB
#
vlan batch 10
#
interface Vlanif10
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
Issue 03 (2010-09-20)