Starting The Nqa Mtrace Test - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
ttl number
The TTL value, that is, the maximum hops traced in max-hop mode is set for the IGMP Tracert-
Request packet.
Step 4 Run:
tracert-livetime first-ttl first-ttl max-ttl max-ttl
The maximum hops traced in hop-by-hop mode is set. first-ttl must be set to 1.
Step 5 Run:
mtrace-last-hop-address ipv4 ip-address
The IP address of the last-hop switch is specified.
Step 6 Run:
source-address ipv4 ip-address
The source IP address of the IGMP Tracert-Request packet is configured. The address must be
the address of the local interface. When the query type is set to multicast-tree, this step is not
required.
Step 7 Run:
mtrace-response-address ipv4 ip-address [ ttl value ]
The destination IP address and TTL of the IGMP Tracert-Response packet are set.
Step 8 Run:
timeout time
The timeout period for waiting for the IGMP Tracert-Response packet is set.
Step 9 Run:
probe-count number
The maximum number of times for the querier to initiate MTrace operations in the timeout
situations is set. The querier re-initiates an MTrace operation if receiving no IGMP Tracert-
Response packet within the timeout period.
Step 10 Run:
quit
Exit from the test instance view.
----End

6.24.5 Starting the NQA MTrace Test

This part describes how to start the MTrace test instance to perform the MTrace test for the
multicast path from the multicast source to the destination host.
6-92 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)