Introduction To Ntp - Huawei Quidway S9300 Configuration Manual - Network Management

3 NTP Configuration

3.1 Introduction to NTP

This part describes the application and working principles of NTP.
NTP(Network Time Protocol) aims to synchronizing clocks of all devices in a network. It keeps
all the clocks of these devices consistent, and enables devices to implement various applications
based on the uniform time.
Any local system that runs NTP can be time synchronized by other clock sources, and also
functions as a clock source to synchronize other clocks. In addition, mutual synchronization can
be performed by exchanging NTP packets.
NTP packets are encapsulated in UDP packets for transmission and the port used by the NTP
protocol is 123.
NTP Application
NTP is applied to the following situations where all the clocks of devices in a network need to
be consistent:
l
l
l
l
l
When all the devices on a network need to be synchronized, it is almost impossible for an
administrator to manually change the system clock by executing command lines. This is because
the work load is heavy and clock accuracy cannot be ensured. NTP can quickly synchronize the
clocks of network devices and ensure their precision.
NTP has the following advantages:
l
l
l
Principles of NTP
Figure 3-1
They both have their own system clocks. NTP implements automatic synchronization of their
clocks.
Suppose:
l
3-2
Network management: Analysis on logs or debugging information collected from different
devices should be performed based on time.
Charging system: requires the clocks of all devices to be consistent.
Completing certain functions: For example, timing restart of all the devices in a network
requires the clocks of all the devices be consistent.
Several systems working together on the same complicate event: Systems have to take the
same clock for reference to ensure a proper sequence of implementation.
Incremental backup between the backup server and clients: Clocks on the backup server
and clients should be synchronized.
Defining clock accuracy by means of stratum to synchronize the time of network devices
in a short time
Supporting access control and MD5 authentication
Transmitting packets in unicast, multicast or broadcast mode
shows the principles of NTP. Switch A and Switch B are connected through a WAN.
Before the system clocks of Switch A and Switch B are synchronized, the clock of Switch
A is set to 10:00:00 am and the clock of Switch B is set to 11:00:00 am.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)