Configuring Parameters For The Path Jitter Test - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
No.
3
4

6.20.2 Configuring Parameters for the Path Jitter Test

This part describes how to set path jitter test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type pathjitter
The type of the test instance is configured as path jitter.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Run the following commands to configure other parameters for the path jitter test:
l Run:
l Run:
l Run:
l Run:
Issue 03 (2010-09-20)
Data
(Optional) Name of a VPN instance, source IP address , number of test probes sent
each time, number of test packets sent each time, interval for sending test packets,
ratio of the failed NQA tests, and version number of jitter packets
Start mode and end mode
icmp-jitter-mode { icmp-echo | icmp-timestamp }
The mode of the path jitter test is configured.
vpn-instance vpn-instance-name
The VPN instance to be tested is configured.
source-address ipv4 ip-address
The source IP address is configured.
probe-count number
The number of test probes to be sent each time is set.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-69