Huawei Quidway S9300 Configuration Manual - Network Management page 446

6 NQA Configuration
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Create an ICMP NQA test group on Switch A.
<SwitchA> system-view
[SwitchA] nqa test-instance group icmp
[SwitchA-nqa-group-icmp] test-type icmp
[SwitchA-nqa-group-icmp] switch-to group
[SwitchA-nqa-group-icmp] quit
Step 3 On Switch A, create two tests named admin test1 and admin test2 respectively to check whether
Switch B and Switch C are reachable.
[SwitchA] nqa test-instance admin test1
[SwitchA-nqa-admin-test1] test-type icmp
[SwitchA-nqa-admin-test1] join group nqa group icmp
[SwitchA-nqa-admin-test1] destination-address ipv4 10.1.1.2
[SwitchA-nqa-admin-test1] quit
[SwitchA] nqa test-instance admin test2
[SwitchA-nqa-admin-test2] test-type icmp
[SwitchA-nqa-admin-test2] join group nqa group icmp
[SwitchA-nqa-admin-test2] destination-address ipv4 10.2.1.2
[SwitchA-nqa-admin-test2] quit
Step 4 Return to the test group view and set the test to be performed after 10 seconds.
[SwitchA] nqa test-instance group icmp
[SwitchA-nqa-group-icmp] start delay seconds 10
# After running the display nqa-agent command, you can view the status of the test group and
the test members on the client.
[SwitchA-nqa-group-icmp] display nqa-agent
nqa test-instance group icmp
test-type icmp
switch-to group
nqa status : group leader, group members number : 2
nqa test-instance admin test1
test-type icmp
destination-address ipv4 10.1.1.2
join group nqa group icmp
nqa status : group member, belong to group : group icmp
nqa test-instance admin test2
test-type icmp
destination-address ipv4 10.2.1.2
join group nqa group icmp
nqa status : group member, belong to group : group icmp
Step 5 Verify the test result 20 seconds later.
[SwitchA-nqa-admin-icmp] display nqa results
NQA entry(admin, test1) :testflag is inactive ,testtype is icmp
1 . Test 1 result
6-226
Host addresses of Switch B and Switch C
Time when the test group is enabled
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Issue 03 (2010-09-20)