Example For Configuring The Udp Test - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
l
l

6.37.9 Example for Configuring the UDP Test

Networking Requirements
As shown in
transmitted between Switch A and Switch C.
Issue 03 (2010-09-20)
#
sysname SwitchA
#
vlan batch 100
#
interface Vlanif100
ip address 10.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
nqa test-instance admin tcp
test-type tcp
destination-address ipv4 10.2.1.2
destination-port 9000
#
ip route-static 10.2.1.0 255.255.255.0 10.1.1.2
#
return
Configuration file of Switch B
#
sysname SwitchB
#
vlan batch 100 110
#
interface Vlanif100
ip address 10.1.1.2 255.255.255.0
#
interface Vlanif110
ip address 10.2.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
return
Configuration file of Switch C
#
sysname SwitchC
#
vlan batch 110
#
interface Vlanif110
ip address 10.2.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
nqa-server tcpconnect 10.2.1.2 9000
#
ip route-static 10.1.1.0 255.255.255.0 10.2.1.1
#
return
Figure 6-11, the NQA UDP Public test is used to obtain RTT of a UDP packet
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-157