Huawei Quidway S9300 Configuration Manual - Network Management page 430

6 NQA Configuration
1.
2.
3.
4.
5.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Configure a dynamic multi-hop PW.
Configure a dynamic multi-hop PW on the MPLS backbone network.
For the detailed configuration procedure, see "PWE3 Configuration" in the Quidway S9300
Terabit Routing Switch Configuration Guide - VPN.
Step 2 Configure a PWE3 Ping test on a multi-hop PW.
# Configure U-PE1.
<U-PE1> system-view
[U-PE1] nqa test-instance test pwe3ping
[U-PE1-nqa-test-pwe3ping] test-type pwe3ping
[U-PE1-nqa-test-pwe3ping] local-pw-id 100
[U-PE1-nqa-test-pwe3ping] local-pw-type ppp
[U-PE1-nqa-test-pwe3ping] label-type control-word
[U-PE1-nqa-test-pwe3ping] remote-pw-id 200
Step 3 Perform the test.
[U-PE1-nqa-test-pwe3ping] start now
Step 4 Verify the test result.
After running the display nqa results command on the PE device, you can see that the test is
successful.
[U-PE1-nqa-test-pwe3ping] display nqa results
NQA entry(test, pwe3ping) :testFlag is inactive ,testtype is pwe3ping
1 . Test 1 result
6-210
Run the IGP protocol on the backbone network to make the routes between Switches on
the backbone network reachable.
Configure the basic MPLS functions on the backbone network and set up an LSP tunnel.
Set up MPLS LDP peer relations between U-PE1 and S-PE, and between U-PE2 and S-
PE.
Create an MPLS L2VC connection between the two U-PEs.
Create a switching PW on the switching node S-PE.
Configure a PWE3 Ping test on the multi-hop PW on U-PE1.
L2VC IDs on U-PE1 and U-PE2, which must be different
MPLS LSR-IDs of U-PE1, S-PE, and U-PE2
IP address of the remote peer
Encapsulation type of the switching PW
Name and parameters of the PW template on U-PE devices
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Min Positive Jitter: 0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Receive response times: 3
OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
Min Negative Jitter: 0
Issue 03 (2010-09-20)