Huawei Quidway S9300 Configuration Manual - Network Management page 282

6 NQA Configuration
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type lsptrace
The test type is set to be LSP Traceroute.
Step 4 Run:
lsp-type te
The tunnel type is set to be TE tunnel.
Step 5 Run:
lsp-tetunnel tunnel tunnel-number hot-standby
The TE tunnel interface to be tracerouted is specified and the CR-LSP hotstandby tunnel is set
to be tested.
Step 6 (Optional) Perform the following as required to configure other parameters for the LSP
Traceroute test:
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the response mode of the Echo packet, run the lsp-replymode { no-reply |
l To configure the LSP EXP value, run the lsp-exp exp command.
l To configure after how many hops a test is considered failed, run the tracert-hopfailtimes
l To configure the initial and the maximum TTL values of the packet, run the tracert-
Step 7 Run:
start
The NQA test is started.
The start command has several forms. You can choose one of the following forms as required:
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
6-62
udp | udp-via-vpls | udp-router-alert | level-control-channel } command.
NOTE
In a uni-directional LSP Ping test, if the lsp-replymode no-replay command is configured, the test
result displays that the test fails regardless of whether the test, actually, succeeds or fails. If the test
succeeds, the test result shows the number of timeout packets. If the test fails, the test result shows the
number of discarded packets.
times command.
livetime first-ttl first-ttl max-ttl max-ttl command.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)