Huawei Quidway S9300 Configuration Manual - Network Management page 366

6 NQA Configuration
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure Switch C as the FTP server.
<SwitchC> system-view
[SwitchC] ftp-server enable
[SwitchC] aaa
[SwitchC-aaa] local-user user1 password cipher hello
[SwitchC-aaa] local-user user1 service-type ftp
[SwitchC-aaa] local-user user1 ftp-directory cfcard:
[SwitchC-aaa] quit
Step 3 Configure an NQA FTP test on Switch A and create a file of 10K bytes for uploading.
<SwitchA> system-view
[SwitchA] nqa test-instance admin ftp
[SwitchA-nqa-admin-ftp] test-type ftp
[SwitchA-nqa-admin-ftp] destination-address ipv4 10.2.1.2
[SwitchA-nqa-admin-ftp] source-address ipv4 10.1.1.1
[SwitchA-nqa-admin-ftp] ftp-operation put
[SwitchA-nqa-admin-ftp] ftp-username user1
[SwitchA-nqa-admin-ftp] ftp-password hello
[SwitchA-nqa-admin-ftp] ftp-filename nqa-ftp-test.txt
[SwitchA-nqa-admin-ftp] ftp-filesize 10
Step 4 Perform the test.
[SwitchA-nqa-admin-ftp] start now
Step 5 Verify the test result.
# Verify the NQA test result on Switch A.
# On Switch C, you can see that a file named nqa-ftp-test.txt is added.
<SwitchC> dir
Directory of cfcard:
506,744 KB total (496173 KB free)
----End
Configuration Files
l
6-146
0 -rw- 331 Feb 06 2009 18:34:34
1 -rw- 10240 Feb 06 2009 18:37:06
Configuration file of Switch A
#
sysname SwitchA
#
vlan batch 10
#
interface Vlanif10
ip address 10.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
nqa test-instance admin ftp
test-type ftp
destination-address ipv4 10.2.1.2
source-address ipv4 10.1.1.1
ftp-operation put
ftp-filesize 10
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
private-data.txt
nqa-ftp-test.txt
Issue 03 (2010-09-20)