Configuring The Mac Ping Test; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
NQA entry(admin, jitter) :testflag is inactive ,testtype is jitter
1 . Test 1 result

6.15 Configuring the MAC Ping Test

This section describes how to perform the MAC ping test with NQA.

6.15.1 Establishing the Configuration Task

6.15.2 Setting Parameters for the MAC Ping Test
6.15.3 Checking the Configuration
6.15.1 Establishing the Configuration Task
Applicable Environment
After you configure the MAC ping test, you can check the connectivity between two or more
devices by using the LBM and LBR packets defined by 802.1ag and collect statistics.
Pre-configuration Tasks
Before configuring the MAC ping test, complete the following task:
l
Data Preparation
To configure the MAC ping test, you need the following data.
6-42
The test is finished
SendProbe:60
Completion:success
OWD OverThresholds SD number:0
Min/Max/Avg/Sum RTT:1/1/1/60
NumOfRTT:60
Operation sequence errors number:0
System busy operation number:0
Min Positive SD:1
Max Positive SD:1
Positive SD Number:3
Positive SD Sum:3
Positive SD Square Sum:3
Min Negative SD:1
Max Negative SD:1
Negative SD Number:3
Negative SD Sum:3
Negative SD Square Sum:3
Min Delay SD:0
Avg Delay SD:0
Max Delay SD:0
Delay SD Square Sum:0
Packet Loss SD:0
Packet Loss Unknown:0
Average of Jitter SD:1
jitter out value:0.0062500
NumberOfOWD:60
OWD SD Sum:0
ICPIF value: 0
Enabling connectivity fault management (CFM) globally so that the maintenance
association end points (MEPs) of the same level can reside on the same VLAN
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
ResponseProbe:60
RTD OverThresholds number:0
OWD OverThresholds DS number:0
RTT Square Sum:60
Drop operation number:0
RTT Stats errors number:0
Operation timeout number:0
Min Positive DS:1
Max Positive DS:1
Positive DS Number:1
Positive DS Sum:1
Positive DS Square Sum:1
Min Negative DS:1
Max Negative DS:1
Negative DS Number:1
Negative DS Sum:1
Negative DS Square Sum:1
Min Delay DS:0
Avg Delay DS:0
Max Delay DS:0
Delay DS Square Sum:0
Packet Loss DS:0
Average of Jitter:1
Average of Jitter DS:1
jitter in value:0.0020833
Packet Loss Ratio: 0%
OWD DS Sum:0
MOS-CQ value: 0
Issue 03 (2010-09-20)