Configuring The Hlhostcontroltable; Configuring The Protocoldirtable - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management

2.4.2 Configuring the hlHostControlTable

HlHostControlTable is used to monitor the traffic of a specific host.
Context
Do as follows on the switch that is monitored.
Procedure
Step 1 Run:
system-view
Step 2 Run:
rmon2 hlhostcontroltable index ctrl-index [ datasource interface { interface-type
interface-number } ] [ maxentry maxentry-value ] [ owner owner-name ] [ status
{ active | inactive } ]
The hlHostControlTable is monitored.
To collect traffic statistics on an interface, create entries for the hlHostControlTable on the
interface.
The index is used to determine if there is a need to create an entry or to change the existing entry.
Configure the datasource interface(namely hlHostControlDataSource) parameter to create an
entry. Only a single entry can be created in the hlHostControlTable for each interface, and the
entry cannot be created repeatedly.
When the hlHostControlStatus value is set to inactive, all related entries in the host table are
deleted automatically.
When the hlHostControlStatus value is set to active, you cannot change the
hlHostControlDataSource and hlHostControlNlMaxDesiredEntries values.
When the physical status of the interface that corresponds to the hlHostControlDataSource is
Down and the hlHostControlStatus value is active, the state is switched to notinservice
automatically. The status displayed in the command output is "plug-out" while on the NM
Station, the status displayed is "notinservice". In this case, users can delete the entry but they
cannot change it. When the interface status turns to Up, the status of the hlHostControlTable
becomes active again.
If an interface that corresponds to the hlHostControlDataSource in an entry is deleted, the entry
is deleted at the same time.
----End

2.4.3 Configuring the ProtocolDirTable

RMON2 can collect only the IP packet statistics on Ethernet interfaces.
Context
Do as follows on the switch that is monitored.
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 RMON and RMON2 Configuration
2-13