Configuring The Snmp Query Test; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Context
Procedure
Step 1 Run the display nqa results [ test-instance admin-name test-name ] command to view the test
results on the NQA client.
----End
Example
Run the display nqa results command. If the statistics of each hop is displayed, it means that
the test is successful.
<Quidway> display nqa results
NQA entry(t, t) :testflag is inactive ,testtype is trace
1 . Test 1 result

6.11 Configuring the SNMP Query Test

This section describes how to configure a Simple Network Management Protocol (SNMP) query
test to check the communications between the host and SNMP agent.

6.11.1 Establishing the Configuration Task

Before configuring an SNMP query test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
6.11.2 Configuring the SNMP Query Test Parameters
This part describes how to set SNMP query test parameters.
6.11.3 Checking the Configuration
After configuring the SNMP query test, you can view the test result.
6.11.1 Establishing the Configuration Task
Before configuring an SNMP query test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Issue 03 (2010-09-20)
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
The test is finished
Completion:success
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Drop operation number:0
Last good path Time:2010-06-21 15:41:01.7
1 . Hop 1
Send operation times: 3
Min/Max/Average Completion Time: 1/2/1
Sum/Square-Sum Completion Time: 4/6
RTD OverThresholds number: 0
Last Good Probe Time: 2010-06-21 15:41:01.7
Destination ip address:10.112.58.3
Lost packet ratio: 0 %
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Attempts number:1
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
Receive response times: 3
6 NQA Configuration
6-27