Configuring Round-Trip Delay Thresholds; Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management

6.31.2 Configuring Round-Trip Delay Thresholds

This part describes how to set a round-trip transmission delay threshold. When the transmission
duration exceeds the threshold, a trap message is sent to the Network Management System
(NMS).
Context
Do as follows on the switch to perform the NQA test:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the NQA instance view is displayed.
Step 3 Run:
threshold rtd rtd-value
The round-trip transmission delay threshold is configured.
Step 4 Run:
send-trap rtd
The trap function is enabled.
----End

6.31.3 Checking the Configuration

After setting the round-trip transmission delay threshold, you can view the configuration.
Prerequisite
The configurations of the Round-Trip Delay Thresholds Test function are complete.
Procedure
Step 1 Run the display nqa-agent [ admin-name test-name ] [ verbose ] to view the status of the test
instance configured on the NQA client.
----End
Example
Run the display nqa-agent verbose command. If the test is successful, the following is
displayed. For example:
<Quidway> display nqa-agent verbose
NQA Tests Max:2000
NQA Flow
Issue 03 (2010-09-20)
NQA Tests
Max:1000 NQA Flow Remained:1000
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Number: 1
6 NQA Configuration
6-121