Checking The Configuration; Configuring The Traceroute Test - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
----End

6.9.3 Checking the Configuration

After configuring the DNS test, you can view the test result.
Prerequisite
The configurations of the DNS Test function are complete.
Context
Procedure
Step 1 Run the display nqa results [ test-instance admin-name test-name ] command to view the test
results on the NQA client.
----End
Example
Run the display nqa results command. If the test is successful, the following is displayed.
<Quidway> display nqa results
NQA entry(t, t) :testflag is inactive ,testtype is dns
1 . Test 1 result

6.10 Configuring the Traceroute Test

This section describes how to configure a traceroute test to check the connectivity to each hop
on the network.
6.10.1 Establishing the Configuration Task
Before configuring a traceroute test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
6.10.2 Configuring Traceroute Test Parameters
This part describes how to set traceroute test parameters.
6-24
The test instance is started after a certain delay.
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
The test is finished
Send operation times: 1
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:10.82.55.191
Min/Max/Average Completion Time: 4/4/4
Sum/Square-Sum Completion Time: 4/16
Last Good Probe Time: 2010-06-21 15:40:12.6
Lost packet ratio: 0 %
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Receive response times: 1
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
Issue 03 (2010-09-20)