Configuring The Http Test - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
Prerequisite
The configurations of the FTP Upload Test function are complete.
Context
Procedure
Step 1 Run the display nqa results command to view the test results on the NQA client.
----End
Example
Run the display nqa results command. If the test is successful, the following is displayed.
l
l
l
<Quidway> display nqa results
NQA entry(admin, ftp) :testflag is inactive ,testtype is ftp
1 . Test 1 result

6.8 Configuring the HTTP Test

This section describes how to configure a Hypertext Transfer Protocol (HTTP) test to check the
responding speed of the HTTP service in each phase.
6.8.1 Establishing the Configuration Task
Before configuring an HTTP test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
6.8.2 Configuring HTTP Test Parameters
This part describes how to set HTTP test parameters.
6.8.3 Checking the Configuration
After configuring the HTTP test, you can view the test result.
6-18
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
"CtrlConnTime"
"DataConnTime"
"SumTime"
The test is finished
SendProbe:1
Completion :success
MessageBodyOctetsSum: 448
Operation timeout number: 0
Drop operation number:0
CtrlConnTime Min/Max/Average: 438/438/438
DataConnTime Min/Max/Average: 218/218/218
SumTime Min/Max/Average: 656/656/656
Average RTT:380
Lost packet ratio: 0 %
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
ResponseProb:1
RTD OverThresholds number: 0
Stats errors number: 0
System busy operation number:0
Disconnect operation number: 0
Issue 03 (2010-09-20)